Legrand 364672-02 User Manual download pdf

INSTRUCTION / INSTALLATION SHEET

Pre-Construction Speaker Brackets

IS-0243 Rev. A

301 Fulling Mill Road, Suite G

Middletown, PA 17057

Phone (800) 321-2343 / Fax (717) 702-2546

www.onqlegrand.com

1. Introduction

On-Q/Legrand offers four (4) styles of Pre-Construction

Speaker Brackets; 6.5” (364672-02) and 8” (364673-02) In-

Ceiling and 6.5” (364674-02) and 8” (364675-02) In-Wall.

These speaker brackets are optimized for an easy and

flexible installation. They employ shatter proof aluminum

wings that have an integrated adjustment channel built in

and pre-wiring loops to aid in finding the speaker wire at

finish time, keeping it out of the way of the dry-wall saw. All

pre-construction brackets also come with center markings

for easy alignment with other devices in the ceiling.

2. Description

On-Q In-Ceiling and In-Wall speaker brackets are made of tough semi-flexible plastic frames and shatter proof

aluminum wings. These brackets can be used with 16” and 24” on center joist/stud spacing. They employ a

unique alignment channel that eases installation and adjustment for the installer especially when working from a

ladder. This adjustment channel allows the installer to confirm, adjust or remove the bracket before committing

to its final position without having to worry about damaging the bracket upon removal/adjustment.

3. Installation

NOTE: Please have dry-wall screws and or nails/staples handy for installation.

Figures 3 – 7 are on page 2.

A. Determine where in the room the speaker brackets will need to be located. After

determining, measure from a fixed location and mark the corresponding joists/studs.

(See Figure 1)

B. Attach one end of the bracket with a drywall screw through the adjustment

channel into the measurement mark. (See Figure 2)

C. Adjust the bracket so that the other side aligns with the other marking and

install a screw through the speaker brackets adjustment channel.(See Figure 3)

D. If the bracket needs to be aligned with another object within the space, such as a

recessed light, leave the screws loose and slide the bracket until aligned with the

object.

NOTE: Each speaker bracket has a center marking for easy measuring.

(See Figure 4)

E. After the speaker bracket is properly positioned install some additional screws or

nails to lock down its location. Screws might be preferred if movement or removal

could be required at a later date. (See Figure 5)

F. It is recommended to install blocking and insulation for the best possible sound

quality. Refer to the On-Q speaker cubic footage chart included with the speaker

instruction sheet. (See Figure 6)

On-Q/Legrand Pre-Construction Speaker

Brackets

Figure 2

Figure 1

1 2

IS-0243 Rev. A 1

Summary of Contents

Page 1 - IS-0243 Rev. A

INSTRUCTION / INSTALLATION SHEETPre-Construction Speaker Brackets IS-0243 Rev. A301 Fulling Mill Road, Suite G Middletown, PA 17057 Phone (800) 321-23

Page 2

INSTRUCTION / INSTALLATION SHEETPre-Construction Speaker Brackets IS-0243 Rev. A301 Fulling Mill Road, Suite G Middletown, PA 17057 Phone (800) 321-23