Legrand 364685-01 User Manual download pdf

IS-0248 Rev. O Page 1 of 1

Installation/Instruction Sheet

Mini Coax Stripper /

Replacement Blades

IS-0248 Rev O

OnQ Technologies, Inc.

P.O. Box 60907

Harrisburg, PA 17106-0907

800-321-2343

www.onqtech.com

TO STRIP CABLE:

1. While holding the tool, depress the lever. Insert the cable across the cartridge in the direction of the arrow until

it hits the stop.

2. Let go of the lever. Supporting the cable with one hand, insert forefinger of the other hand into the large hole on

the opposite end of the tool. Spin the tool approximately three revolutions. You will hear the braid cutting and

feel the tool spin freely. At this point you can reverse the spin. Depending on the cable you are using, the

number of reverse spins will vary.

3. Grasp tool firmly around the cartridge without depressing the lever and pull the tool away from the cable.

NOTE: The notched blade in the cartridge eliminates the risk of scoring the center conductor and cuts through

the jacket, braid, foil and dielectric leaving the center conductor exposed. The Shallow blade cuts through only

the jacket of the cables.

TIP: After stripping the cable, depress the lever. A tab will move up between the blades and remove any remaining

debris.

REPLACING CARTRIDGES:

The purpose of this tool is to provide consistent quality, while saving time. For this tool to perform correctly, the

cartridge must be replaced when the blades are dull. Depending on the cable you are using, the number of cuts per blade

cartridge varies. For best performance the blade should be kept free of debris. If you see that the cut is not as clean, the

braid is not cut evenly, or the tool takes more revolutions to perform the cut – REPLACE THE CARTRIDGE

IMMEDIATELY.

HOW TO REPLACE THE CARTRIDGE:

While holding the tool, depress the lever and grasp the cartridge on both sides. Then pull cartridge toward the lever to

remove. Reverse this process for cartridge installation, snapping the cartridge in place. Move fingers away from cartridge

and let go of lever.

TO BE USED WITH THE FOLLOWING OnQ PART NUMBERS:

364682-01 - AnyPort Express Mini Coax “F” Plug

364683-01 - AnyPort Express Mini Coax RCA Plug

364684-01 - AnyPort Express Mini Coax BNC Plug

364710-01 - AnyPort Express Universal Crimp Tool

364686-xx - Mini Coax Cable (250 ft.)

(xx indicates color: 01 = red, 02 = yellow, 03 = blue, 04 = black, 05 = white, 06 = green)

Summary of Contents

Page 1

IS-0248 Rev. O Page 1 of 1 Installation/Instruction Sheet Mini Coax Stripper / Replacement Blad

Comments to this Manuals

No comments

Legrand 364685-01 User Manual

Browse online or download User Manual for Hardware Legrand 364685-01. Legrand 364685-01 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Legrand 364685-01