Legrand RC3 Receptacle Replacement User Manual

Browse online or download User Manual for Hardware Legrand RC3 Receptacle Replacement. Legrand RC3 Receptacle Replacement User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 6
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
RC3, RC7 & RC4
Receptacle Replacement
INSTALLATION INSTRUCTIONS
Installation Instruction No.: 1 003 786R1 – Updated October 2003
Products Covered: RC37REC, RC4REC2, RC37REC-25 and RC4REC2-25
IMPORTANT: Please read all instructions
before beginning.
Walker
®
electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Walker electrical products
may bear the mark as UL Listed and/or Classified and should
be installed in conformance with current local and/or the National
Electrical Code.
Step 1 Remove junction box cover and disconnect wires.
Step 2 Remove slide holder and scrub water gasket.
Step 3 Use screwdriver to disengage snap fingers. Move
screwdriver to the outside and pull up. Repeat on
the other side of the receptacle.
Step 4 Remove receptacle from assembly.
For RC3TC & RC7TC Series Devices
For use with: RC3TC, RC7TC, and RC4TC Series Poke-Thru Devices
CAUTION: De-energize circuit before removing
junction box cover.
Page view 0
1 2 3 4 5 6

Summary of Contents

Page 1 - Receptacle Replacement

RC3, RC7 & RC4Receptacle ReplacementINSTALLATION INSTRUCTIONSInstallation Instruction No.: 1 003 786R1 – Updated October 2003Products Covered:

Page 2

2WHITE or NEUTRALfrom branch circuitWHITEfrom poke-thru receptacleBLACK or HOT from branch circuitBLACKfrom poke-thru receptacleGREEN (jumper wire)fro

Page 3 - For RC4TC Series Devices

3For RC4TC Series DevicesScrewsSlide HolderJunction BoxScrewsTrim RingStep 1 Disconnect receptacle wiring in junction box. Step 2 Remove two screws an

Page 4 - Screws Provided

4Step 5 Pull receptacles and receptacle bracketsout of poke-thru. Step 6 Guide replacement receptacle brackets into place.Direct wire leads through in

Page 5 - Electrical Wiring Chart

5Circuit “A” Circuit “B” Line Black Red Neutral White White w/Blue StripeGround Green Green w/Yellow StripeElectrical Wiring ChartCAUTION: Letter ind

Page 6

The Wiremold Company U.S. and International: 60 Woodlawn Street • West Hartford, CT 061101-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-2

Related models: RC7 | RC4 | RC4REC2 | RC4REC2-25 |

Comments to this Manuals

No comments