Legrand F7596-xx User Manual

Browse online or download User Manual for Hardware Legrand F7596-xx. Legrand F7596-xx User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 1 of 2
INSTRUCTION/INSTALLATION SHEET
inQuire™ 1000 Intercom Door Unit
IS-0368 REV. O
©Copyright 2006 by On-Q/Legrand All Rights Reserved.
1. Introduction
The On-Q /Legrand inQuire™ 1000 Intercom Door Unit, PN F7596-XX (see
Figure 1), is a weather resistant door unit that allows a visitor to notify the
occupants of their presence by pushing the door chime button (requires Door
Chime to be installed). The occupants can then initiate two-way
communications with the visitor and open the door (requires separate door
release device). The Door Unit is available in white (-WH), shiny brass (-SB),
antique brass (-AB), brushed stainless (-BS), or oil-rubbed bronze (-OB).
2. Description
The Door Unit is weather-resistant and contains a speaker, microphone and
button to ring the door chime (requires Door Chime to be installed). The high
quality speaker and microphone provide superior sound quality. The Door
Unit is installed in a 2-gang outdoor weatherproof box typically at electrical
switch box height.
3. Installation
Installation of the inQuire™ 1000 Door Unit is best accomplished at multiple times during new construction, at
“Rough-in” before the drywall and siding is installed, and at “Trim-out” after the drywall is installed.
A. “Rough-in” steps:
1. Run a Cat 5 cable from the Enclosure where the inQuire™ 1000 Intercom Module will be installed to the
2 gang box at the Door Unit location.
NOTE: It is important to keep all Category 5e cable runs, regardless of use, at least 12 inches away
from AC electrical cables. If it proves necessary to cross an existing AC cable, do so only at a 90
degree angle.
B. “Trim-out” steps:
NOTE: All terminations can be correctly completed by following the T568A pin assignments. It is
important that you accurately terminate using T568A at all locations. There are two different types of
terminations you will encounter when installing the inQuire™ 1000 Intercom System: RJ45 plugs on the
Modules, the Main Console and the Room Unit and 110 punchdown blocks on Door and Patio Units. Refer
to Figure 2 for correct T568A termination for both RJ45 plugs and 110 punchdown blocks.
Figure 1
Figure 2
Page view 0
1 2

Summary of Contents

Page 1 - IS-0368 REV. O

301 Fulling Mill Road, Suite G Middletown, PA 17057 Phone (800) 321-2343 / Fax (717) 702-2546 www.onqlegrand.com

Page 2

301 Fulling Mill Road, Suite G Middletown, PA 17057 Phone (800) 321-2343 / Fax (717) 702-2546 www.onqlegrand.com

Comments to this Manuals

No comments