Legrand RC3 Replacement Scrub Water Cover Assembly Kit User Manual download pdf

IMPORTANT – PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING.

Products Covered: RC3KTC

CAUTION: Do Not operate tile stripper or resurfacing equipment over top of covers.

This may result in damage to the surface finish of the product.

Step 1. Remove junction box cover and disconnect wires. Step 2. Remove slide holder.

CAUTION: De-energize circuit before removing junction box cover.

Step 3. Release communication jacks and bezel Step 4. Rotate jack and push through flange as

from trim flange. Do not disconnect the shown below.

communication wires from jacks.

Repeat Steps 3 through 4 for the second jack.

RC3

Replacement Scrub Water

Cover Assembly Kit

INSTALLATION INSTRUCTIONS

Installation Instruction No.: 1 001 588 R1 – Updated December 2003

Walker

electrical systems conform to and should be properly grounded

in compliance with requirements of the current National Electrical Code

or codes administered by local authorities.

All electrical products may present a possible shock or fire hazard if

improperly installed or used. Walker electrical products may bear the

mark as UL Listed and/or Classified and should be installed in

conformance with current local and/or the National Electrical Code.

1 2 3 4 5 6

Summary of Contents

Page 1 - Cover Assembly Kit

IMPORTANT – PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING. Products Covered: RC3KTC CAUTION: Do Not operate tile stripper or resurfacing equipment o

Page 2 - Receptacle Barrier

2Step 5. Remove trim flange. Step 6. Remove receptacle barrier. NOTE: Make sure that the carpet cutout is a 7" [177mm] dia. cutout. If the carp

Page 3 - Wiring Label

3Step 9. Attach internal gasket and slide Step 10. Stick wiring label on the inside of the holder assembly. junction box cover. Reattach receptacle w

Page 4

44The RC3TC Series Poke-Thru Device is UL Listed and Classified to U.S. and Canadian safety standards to the following conditions: The RC3STC Poke-Thr

Page 5 - CARPET CUTOUT TEMPLATE

Carpet Cutout7" [178mm]Core Hole 4 1/16" [103mm]CAUTION: When printing copies ofthis template please besure template is scaledcorrectly and

Page 6

The Wiremold Company U.S. and International: 60 Woodlawn Street • West Hartford, CT 061101-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-2

Comments to this Manuals

No comments

Legrand RC3 Replacement Scrub Water Cover Assembly Kit User Manual

Browse online or download User Manual for Hardware Legrand RC3 Replacement Scrub Water Cover Assembly Kit. Legrand RC3 Replacement Scrub Water Cover Assembly Kit User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Legrand RC3 Replacement Scrub Water Cover Assembly Kit