Legrand AC1023 User Manual download pdf

INSTRUCTION / INSTALLATION SHEET

Intercom / Unity Relay Module (P/N

AC1023)

IS-0504 Rev. B

301Fulling Mill Road, Suite G

Middletown, PA 17057

Phone (800) 321-2343 / Fax (717) 702-2546

www.onqlegrand.com

1. Introduction

The Legrand AC1023 Intercom/Unity Relay Module

(see Figure 1) provides the relay interface between

the SCI Intercom Module (IC5001) or Unity Integration

Module (HA6001) and a third party electronic door

strike. This relay module supports a remote door

release capability as part of an SCI Intercom or Unity

system. It supports a 12 VDC door strike and is

supply.

2. Description

• Provides one 2.5mm DIN jack (or 2-pin cage connector labeled “POWER”) for connection to a third party 12 VDC

AC to DC power adapter.

• Provides one 2-pin cage connector (labeled “CTRL”) for connection to the SCI or Unity Integration Module.

• Provides one 2-pin cage connector (labeled “OUT”) for connection (up to 2A) to the electronic door strike.

• Provides one 4-pin cage connector (labeled “DRY CONTACT”) that supports a Normally Closed (plus Common)

and Normally Open (plus Common) connections for use when a dry contact is used to initiate the door strike

(rather than the SCI or Unity system).

3. Installation

Installation of the Legrand AC1023 and related components is best accomplished at multiple times during new

construction, at “Rough-in” before the drywall is installed, and at “Trim-out” after the drywall is installed and painted

(see Figure 2).

IMPORTANT: Read the manuals that are included with all associated Unity products before installation of

any single component. If you are unsure of any of the following installation procedures contact Legrand

Technical Support @ 1-800-321-2343 option 1 or contact a Legrand installer.

A. “Rough-in” steps:

1. AC1023: Run a 16/2 cable from the door release location to the enclosure housing the

AC1023.

2. AC1023 (optional): Run a 16/2 cable from the optional Normally Closed or Normally Open contact

location to the enclosure housing the AC1023.

B. “Trim-out” steps:

NOTE: Make sure that the 12VDC Power Supply is not connected to the AC1023 Module.

1. Install the AC1023 in the enclosure by first attaching it to a single bay opening in an existing

bracket using the four corner plungers.

Figure 1

1 2

AC1023) 1

Summary of Contents

Page 1 - AC1023)

INSTRUCTION / INSTALLATION SHEETIntercom / Unity Relay Module (P/N AC1023) IS-0504 Rev. B 301Fulling Mill Road, Suite G Middletown, PA 17057 Phone (80

Page 2

INSTRUCTION / INSTALLATION SHEETIntercom / Unity Relay Module (P/N AC1023) IS-0504 Rev. B 301Fulling Mill Road, Suite G Middletown, PA 17057 Phone (80

Comments to this Manuals

No comments

Legrand AC1023 User Manual

Browse online or download User Manual for Hardware Legrand AC1023. Legrand AC1023 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Legrand AC1023