Legrand IC5001 User Manual download pdf

INSTRUCTION / INSTALLATION SHEET

Selective Call Intercom Distribution

Module

IS-0385 Rev. B

301Fulling Mill Road, Suite G

Middletown, PA 17057

Phone (800) 321-2343 / Fax (717) 702-2546

www.onqlegrand.com

1. Introduction

The Legrand Selective Call Intercom Distribution Module (P/N IC5001) is a single bay module that supports

the audio, power and control requirements of up to 8 units in any combination of Room, Door and Patio (see

Figure 1).

2. Description

The Selective Call Intercom Distribution Module is located in the enclosure and connected to each Room,

Door and Patio Unit via a single Cat 5 cable. Up to eight units of any combination are supported by each

module and modules may be cascaded three times, for a total system support of up to 32 Units. The RJ45

jacks labeled “1-8” are used for the various Units, with jack 8/V1 supporting Video Door Units. The jacks

labeled “IN” and “OUT” are used for cascading modules. The jack labeled “AUDIO INT” is used to connect to

the lyriQ™ Audio Distribution System to automatically mute the whole house audio when the Intercom system

is utilized. The “VIDEO OUT” RCA jack is used to output images from a Video Door Unit. The Module comes

with a single bay bracket for mounting in an On-Q style enclosure.

NOTE: The maximum Cat 5 cable run distance between the SCI Module and another unit (Module,

Door, Patio or Room Unit) is 330’ with the following exception. One Door or Patio Unit may be placed

up to 1000’ (up to 650’ for a Video Door Unit) from the SCI Module, but it needs to be locally powered

and Legrand needs to be informed of and pre-approve this type of installation. If the Cat 5 run is

buried in an underground conduit, it should maintain a 16” separation from any 110VAC wiring.

Additional SCI Modules are recommended to be placed in the same enclosure, powered from the

same power strip, and interconnected with the shortest Cat 5 connections possible.

3. Installation

Installation of the Selective Call Intercom Distribution Module is best accomplished at multiple times during

new construction, at “Rough-in” before the drywall is installed, and at “Trim-out” after the drywall is installed

and painted.

A. “Rough-in” steps:

1. Run a single Cat 5e cable from the Enclosure where the Selective Call Intercom Distribution Module will

be installed to each of the 2 gang boxes at the eventual Room, Door and Patio Unit locations.

Figure 1

1 2 3 4

IS-0385 Rev. B 1
(rear view) 3

Summary of Contents

Page 1 - IS-0385 Rev. B

INSTRUCTION / INSTALLATION SHEETSelective Call Intercom Distribution Module IS-0385 Rev. B 301Fulling Mill Road, Suite G Middletown, PA 17057 Phone (8

Page 2

INSTRUCTION / INSTALLATION SHEETSelective Call Intercom Distribution Module IS-0385 Rev. B 301Fulling Mill Road, Suite G Middletown, PA 17057 Phone (8

Page 3 - (rear view)

INSTRUCTION / INSTALLATION SHEETSelective Call Intercom Distribution Module IS-0385 Rev. B 301Fulling Mill Road, Suite G Middletown, PA 17057 Phone (8

Page 4

INSTRUCTION / INSTALLATION SHEETSelective Call Intercom Distribution Module IS-0385 Rev. B 301Fulling Mill Road, Suite G Middletown, PA 17057 Phone (8

Comments to this Manuals

No comments

Legrand IC5001 User Manual

Browse online or download User Manual for Hardware Legrand IC5001. Legrand IC5001 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Legrand IC5001