Legrand SAF User Manual download pdf

Step 1 Cut or form an 8 1/16" x 10 1/8" [205mm x

257mm] (+ 1/16" - 0") opening in the raised

floor panel and carpet. (See Fig. 1.)

Step 2 Blank communication plates come standard in floor box.

If other communication plates are required, remove

communication conduit plate. (See fig 2.) Remove only

blank communication plates that need exchanged and

attach new communication plates (sold separately) to

the floor box using (2) #8-32 x 3/8" self-tapping

screws provided. (See fig 3.) Reattach communication

compartment cover. ( See fig 2.)

FIG. 1

FIG. 3

FIG. 2

Communication

Conduit Plate

NOTE: Communication conduit plate

required only if using conduit to supply

communications cabling. (See Step 5.)

SAF21/2

Raised Floor Box

I N S T A L L A T I O N I N S T R U C T I O N S

Installation Instruction No.: 1 002 430R3 – Updated January 2011

Legrand/Wiremold electrical systems conform to and should be properly

grounded in compliance with requirements of the current National

Electrical Code or codes administered by local authorities.

All electrical products may present a possible shock or fire

hazard if improperly installed or used. Legrand/Wiremold electrical

products may bear the mark of a Nationally Recognized Testing

Laboratory (NRTL) and should be installed in conformance with current

local and/or the National Electrical Code.

IMPORTANT: Please read all instructions

before beginning.

PRODUCTS COVERED: SAF21/2

NOTE: Products are suitable for use in air handling spaces in accordance with Sec. 300-22(C) of the National Electrical Code.

CAUTION: Flange is an integral part of the box assembly. DO NOT REMOVE.

1 2 3 4

SAF21/2 1

Summary of Contents

Page 1 - SAF21/2

Step 1 Cut or form an 8 1/16" x 10 1/8" [205mm x257mm] (+ 1/16" - 0") opening in the raisedfloor panel and carpet. (See Fig. 1.)St

Page 2

Step 3 Place Walker Shallow Raised Floor Box inopening created in step one. (See Fig. 4.)Step 4 Using a Phillips screwdriver tighten the (2)#10-24 X 2

Page 3

Step 6 Attach electrical conductors to the UL Listedduplex receptacles (provided by others). Make sure that any ground leads are connected to ground s

Page 4

NOTE: The Walker Shallow Raised Floor Box should be used on access floor installations. Do not use in concrete or wood floors.Textured SurfaceCarpetSt

Related models: SGC2-MAAP | SGC2-RT | SGC2-ACT | SGC2-B | SG2-DP | SG2-B |

Comments to this Manuals

No comments

Legrand SAF User Manual

Browse online or download User Manual for Hardware Legrand SAF. Legrand SAF User Manual

Summary of Contents

Related models: SGC2-MAAP | SGC2-RT | SGC2-ACT | SGC2-B | SG2-DP | SG2-B |

Comments to this Manuals

Related products and manuals for Hardware Legrand SAF