Legrand Source 1 437 User Manual download pdf

Source I

INSTALLATION INSTRUCTIONS

Installation Instruction No.: IB0001 R1 – Updated February 2007

Wiremold / Legrand electrical systems conform to and should be

properly grounded in compliance with requirements of the current

National Electrical Code or codes administered by local authorities.

All electrical products may present a possible shock or fire

hazard if improperly installed or used. Wiremold / Legrand electrical

products may bear the mark as UL Listed and/or Classified and should

be installed in conformance with current local and/or the National

Electrical Code.

IMPORTANT: Please read all instructions

before beginning.

Products Covered: 437, 439

NOTE: Source I Fittings will run lengthwise on duct when

insert tabs are oriented toward the center as called

for in these instructions (see Figure 1).

AS A PRESET INSERT (437):

1. Install attaching ring in 2 1/2" [64mm] hole in raceway

before concrete is poured (see Figure A).

2. Hole can be factory prepunched or field drilled. Attaching

ring is secured by tightening locking tabs. Be sure the

locking tabs are oriented toward the center of the raceway

(see Figure B).

3. It is important that tabs on the attaching ring be properly

oriented on the duct so that activations will be aligned in

the desired direction. The mudcap should be securely in

place before the concrete pour. After the pour, chip away

concrete (see Figure C) and remove mudcap.

4. Go to Activation Instructions.

AS AN AFTERSET INSERT (437 or 439):

1. Establish location for the fitting, then core drill a 4" [102mm]

diameter hole in concrete (see Figure A). Do not drill

through the raceway.

2. Drill a 2 1/2" [64mm] diameter hole through the top of the

raceway (see Figure B). It should be located in the center of

the core drilled hole.

3. Install attaching ring on raceway making sure the locking

tabs are oriented toward the center of the raceway (see

Figure C). It is important that tabs on the attaching ring be

properly oriented so that activations will be aligned.

4. Go to Activation Instructions.

Figure 1

Figure A

Figure B

Figure C

Attaching Ring

2 1/2" [64mm]

Hole

Walkerduct

Attaching Ring

Duct Direction

Locking

Tabs

Mudcap

Figure A

Figure B

Figure C

4" [102mm]

Hole

2 1/2" [64mm]

Hole

Duct

Attaching Ring

Duct Direction

Locking

Tabs

Tabs Outward

Duct Direction

1 2

Source I 1
Ring required 2

Summary of Contents

Page 1 - Source I

Source I®INSTALLATION INSTRUCTIONSInstallation Instruction No.: IB0001 R1 – Updated February 2007Wiremold / Legrand electrical systems conform to an

Page 2 - Ring required

Wiremold / LegrandU.S. and International: 60 Woodlawn Street • West Hartford, CT 061101-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-

Related models: Source 1 439

Comments to this Manuals

No comments

Legrand Source 1 437 User Manual

Browse online or download User Manual for Hardware Legrand Source 1 437. Legrand Source 1 437 User Manual

Summary of Contents

Related models: Source 1 439

Comments to this Manuals

Related products and manuals for Hardware Legrand Source 1 437