Legrand WC PK Preset Activation Kit with Extended Receptac User Manual download pdf

PK Preset Activation Kit with

Extended Receptacle Bracket

I N S T A L L A T I O N I N S T R U C T I O N S

Installation Instruction No.: 1 005 083R1 – Updated March 2010

Wiremold electrical systems conform to and should be properly

grounded in compliance with requirements of the current National

Electrical Code or codes administered by local authorities.

All electrical products may present a possible shock or fire

hazard if improperly installed or used. Wiremold electrical products

may bear the mark as UL Listed and/or Classified and

should be installed in conformance with current local and/or the

National Electrical Code.

IMPORTANT: Please read all instructions

before beginning.

Products Covered: WPACREXT Series & DTB-2EXT Series

NOTE: Refer to the current version of Installation Instruction 1 002 300

for instructions on locating Preset and installing Grommet.

Bushing

Grommet

Insulator

Do Not Remove

Cat. No. DTB-2EXT-B

Power Feed from Side Compartment:

1. Do not remove knockout from center compartment.

2. Pull electrical wires through grommet hole in side compartment.

3. Remove knockout from receptacle housing and install bushing.

Route wires through bushing and attach to Listed receptacle.

4. Trim receptacle insulator to fit inside of housing and position

over receptacle.

5. Attach receptacle with insulator to receptacle housing with two

#6-32 screws and nuts (not included). Place housing assembly

in PK Insert and arrange wires to clear side closure.

6. Repeat steps 1 through 5 for other receptacle bracket.

NOTE: Bracket must be installed even if second Receptacle is

not required

7. fasten side closure (Cat. No. DTB-2EXT-B) to preset as shown.

1 2

Summary of Contents

Page 1 - Extended Receptacle Bracket

PK Preset Activation Kit withExtended Receptacle Bracket I N S T A L L A T I O N I N S T R U C T I O N SInstallation Instruction No.: 1 005 083R1 –

Page 2 - Wiremold

Power Feed from Center Compartment:NOTE: Install Receptacle Housing and Grommets as shown in thecurrent version of Installation Instruction 1 002 300.

Comments to this Manuals

No comments

Legrand WC PK Preset Activation Kit with Extended Receptac User Manual

Browse online or download User Manual for Hardware Legrand WC PK Preset Activation Kit with Extended Receptac. Legrand WC PK Preset Activation Kit with Extended Receptacle Bracket User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Legrand WC PK Preset Activation Kit with Extended Receptac