Legrand WKD ProSeries Underfloor Duct Fiber Loop Kit Insta User Manual download pdf

Flush Carpet Plates

Cat. Nos. 428 and 433 Series

INSTALLATION INSTRUCTIONS

Installation Instruction No.: 1 000 206 R2 – Updated June 2007

1. If preset is not exposed, see instructions on page two

for concrete, mudcap and knockout removal.

2. Install link strap using the enclosed self tapping

screws to posts in preset as shown in diagram.

Heads of screws should be slightly below

concrete pour level.

3. Install UL Listed devices if needed to adapter

plate. For Catalog No. 428DR or 428DR2,

receptacle screws must be removed. Use

screws from hardware

bag to attach receptacle to plate.

4. Adjust screws until adapter plates are flush with

finished floor.

5. Secure adapter plate to link straps using (2) #10 x

3/4 flat head screws.

NOTE: To maintain proper ground continuity, tighten

screws to a minimum 10 inch pounds.

6. For 433 Series attach cover plate to duplex

receptacle.

7. For 428B525 attach base plate of service fittings to

adapter plate.

Cat. No. 428DR or 428DR2 (Shown)

Cat. No.433DR or 433DR2 (Shown)

Cat. No. 428B525

Cat. No. 428B075

#10 Flat

Head Screw

Adapter

Plate

Link

Strap

Cat. No.428BL

Wiremold / Legrand electrical systems conform to and should

be properly grounded in compliance with requirements of

the current National Electrical Code or codes administered by

local authorities.

All electrical products may present a possible shock or fire

hazard if improperly installed or used. Wiremold / Legrand

electrical products may bear the mark as UL Listed and/or

Classified and should be installed in conformance with current

local and/or the National Electrical Code.

IMPORTANT: Please read all instructions

before beginning.

1 2

Summary of Contents

Page 1 - Flush Carpet Plates

Flush Carpet PlatesCat. Nos. 428 and 433 SeriesINSTALLATION INSTRUCTIONSInstallation Instruction No.: 1 000 206 R2 – Updated June 20071. If preset i

Page 2 - These must be deburred

®Walkerduct Pro Series Presets:1. Use a Walker insert finder (Cat. No. 480) or other electronic locator to find center of preset. Cut and remove carpe

Comments to this Manuals

No comments

Legrand WKD ProSeries Underfloor Duct Fiber Loop Kit Insta User Manual

Browse online or download User Manual for Hardware Legrand WKD ProSeries Underfloor Duct Fiber Loop Kit Insta. Legrand WKD ProSeries Underfloor Duct Fiber Loop Kit Installation User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Legrand WKD ProSeries Underfloor Duct Fiber Loop Kit Insta