Legrand Multiplex Series Multi-Service Pedestal Service Fi User Manual download pdf

To Install on PK Presets:

1. Cut a 5 5/8" [143mm] x 6 3/4" [171mm] long

(along length of cell run) opening in carpet exactly

centered over preset. (Save for later abandoning).

Remove concrete and mudcap from preset and

grout as required.

2. Use a screwdriver to remove only one power

knockout from cell, then install power grommet.

3. Snap communications cell grommets in place

(refer to instruction sheet 1 000 684).

4. Route electrical conductors and/or communication cables.

5. Attach enclosure to preset and partition to leveling ring.

6. Install leveling ring so top surface will be approximately

1/16" [1.6mm] below top of carpet. Install access covers

(M4 only). Attach base of fitting to leveling ring so that base

is tight against both carpet and ring.

7. Install round grommet and mounting frame into base. Install

partition to separate services if needed. (MP8

size only). Install ground wire between base

and enclosure.

8. Install UL Listed wiring devices and/or communication

services. Cut off excess length on electrical device mount-

ing screw (top screws only). Attach faceplates over each

opening and screw on cover.

Multiplex

™

Service Fitting

INSTALLATION INSTRUCTIONS

Installation Instruction No.: IB0123 R1 – Updated September 2006

PK Series

Cover

Base

Leveling Ring

Partition

Enclosure

Communications Grommet

Power Grommet

Access Cover

Mounting Frame

Faceplate

PK Preset

Wiremold / Legrand electrical systems conform to and should be

properly grounded in compliance with requirements of the current

National Electrical Code or codes administered by local authorities.

All electrical products may present a possible shock or fire

hazard if improperly installed or used. Wiremold / Legrand electrical

products may bear the mark as UL Listed and/or Classified and should

be installed in conformance with current local and/or the National

Electrical Code.

IMPORTANT: Please read all instructions

before beginning.

1 2 3 4

Summary of Contents

Page 1 - Service Fitting

To Install on PK Presets:1. Cut a 5 5/8" [143mm] x 6 3/4" [171mm] long (along length of cell run) opening in carpet exactly centered over p

Page 2 - N-R-G Series

Instructions to Install on N-R-G Presets:1. Install closure plate over unused opening, if needed.2. Snap communication cell grommets in place (refer t

Page 3 - Walkerduct Pro Series Preset:

Install on 2" [51mm] IPS Presets or Aftersets:1. Determine location of insert using any of the following methods:a. Using an electronic insert f

Page 4 - Figure 2

Walkerduct Pro Series™Mudcap and Knockout Removal:1. Use a Walker insert finder (Cat. No. 480) or other electronic locator to find center of preset.

Comments to this Manuals

No comments

Legrand Multiplex Series Multi-Service Pedestal Service Fi User Manual

Browse online or download User Manual for Hardware Legrand Multiplex Series Multi-Service Pedestal Service Fi. Legrand Multiplex Series Multi-Service Pedestal Service Fittings User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Legrand Multiplex Series Multi-Service Pedestal Service Fi